Federal Signal Corporation Navigator Lightbar User Manual (English)

Questions and Answers:

J
Joshua DanielsAug 4, 2025
What to do if my Federal Signal Corporation Navigator Lightbar Lighting Equipment lightbar does not light?
- S
  sbishopAug 4, 2025
  If your lightbar isn't lighting up, start by checking the red power line (+BAT) and the black ground-power line (–GND) to ensure they're properly connected to a fully charged 12-volt battery. Also, check the 40A fuse. Make sure the ground connection from the lightbar controller to the aluminum extrusion is secure. Finally, inspect the fuses on the lightbar controller.
R
Richard FordAug 11, 2025
Why does my Federal Signal Corporation Lighting Equipment lightbar turn off when the Flash Takedown/Alley lights turn on?
- A
  Angela JohnsonAug 11, 2025
  If your lightbar turns off when the Flash Takedown/Alley lights are activated, the first step is to ensure that the vehicle battery is fully charged. Also, check that the lightbar’s red power line (+BAT) and black ground-power line (–GND) are properly connected to a good, fully charged 12-volt battery. Finally, inspect the red power line (+BAT) and the black ground- power line (–GND) connections in the lightbar and vehicle.
P
Paul ChavezAug 20, 2025
What to do if LED module of Federal Signal Corporation Lighting Equipment does not light?
- K
  Kimberly JonesAug 20, 2025
  If an LED module isn't lighting up, try swapping the LED head/bracket assembly with a known working module to see if the board is faulty. Check the connections of the cable that runs from the lightbar controller to the LED ROC board. Also, make sure the Steady Burn switches on the lightbar controller (SW3 PSR for the passenger side and SW3 DSR on the driver side) are correctly set.
A
Amy BushAug 27, 2025
How to fix if half of an LED module of Federal Signal Corporation Navigator Lightbar Lighting Equipment does not light?
- A
  Angela WhiteheadAug 27, 2025
  If half of an LED module isn't lighting up, replace the LED head/bracket assembly.

Federal Signal Corporation Navigator Lightbar Specifications

General

Light Source	LED
IP Rating	IP67
Input Voltage	12-24V DC
Certifications	SAE J845, SAE J595
LED Count	Varies by configuration
Light Output	Varies by configuration
Material	Polycarbonate
Color Options	Amber, Blue, Red, White, Green