SETUP
Installing the Auxiliary Handles
WARNING: To prevent serious
injury: Do not operate this tool
without the auxiliary handle properly
installed.
The D-Handle (included) may be
installed for either right-hand or left-
hand use.
OPTION 1: Using the D-Handle
Attach the D-Handle to the sides of
the front cover, using the hex key
and two hex head bolts.
NOTE: Slide the hex key through
the hole in the handle to access the
bolt on the long side of the handle
OPTION 2: Usin
g with a side
handle (side handle not included)
This tool can be used with many
standard angle grinder side handles
which can be installed on either
side.
Installing the
Backing Pad/Foam
Pad
1. The accessory MUST be:
in diameter
5/8 x 11 TPI
2. Press in and hold the Spindle
Lock Button to prevent the Spindle
from turning.
3. Thread the backing pad onto the
spindle until firmly secured in place.
Workpiece and Work area set
up
1. Designate a work area that is
clean and well-lit. The work area
must be accessible by children or
pets to prevent distraction and
injury.
2. Route the power cord along a
safe route to reach the work area
without creating a tripping hazard
or exposing the power cord to
possible damage. The power cord
m
ust reach the work area with
enough extra length to allow free
movement while working.
3. Secure loose workpieces using
a vise or clamps (not included)
to
prevent movement while working.
4. There must not be hazardous
objects, such as utility lines or
foreign objects nearby that will
present a hazard while working.
OPERATION
Polishing
1. Make sure the surface to polish
has been thoroughly washed, and
is free of dust, dirt, oil, grease,
etc.
2. Place a clean foam pad (sold
separately) securely onto the
backing pad.
3. Apply 2 tablespoons of wax
(not included) evenly on the foam
pad.
Caution: Do not apply the wax
directly to the surface of the
vehicle. The amount of wax
needed will vary according to the
size of the vehicle being waxed.
eedback@natitools.com
1-800-348-5004
To Next Page
Loading...
General