Need help?Do you have a question about the Feelworld LIVEPRO L1 and is the answer not in the manual?
General| Video Inputs | 4 x HDMI |
|---|---|
| Video Outputs | 2 x HDMI |
| Power Supply | DC 12V |
| T-Bar | Yes |
| Audio Inputs | 3.5mm audio jack |
| Audio Outputs | 3.5mm audio jack |
| Control Interface | USB |
| Transitions | Mix, Wipe |
| Effects | PIP |
Introduces the LIVEPRO L1/L2 mixer, its capabilities, compact design, and transition effects.
Illustrates and explains the system connection diagram for input and output devices.
Details the physical buttons, knobs, and TFT display on the device's front panel.
Describes the various input/output ports like HDMI, USB, Audio, and LAN.
Explains how to access and navigate the device's menu structure.
Covers key menu settings such as Input, HDMI, USB3.0, and Audio configurations.
Details IP settings, language selection, and factory reset procedures.
Explains the functionality of buttons for MIX, MODE, PIP, and FX features.
Guides on how to switch video inputs using Fast+Time and T-Bar modes.
Instructions for installing and connecting the XPOSE software to the device.
Overview of the XPOSE software's graphical interface and basic operations.
Steps to set up the FEELWORLD USB 3.0 Capture device within OBS.
Guide to selecting and configuring the correct audio source in OBS.
How to configure RTMP address and stream key for live broadcasting.
Steps for performing firmware upgrades using a LAN connection.
Using the XTOOL application to manage and upgrade device firmware.
How to check the firmware version and confirm a successful upgrade.
Details of all available input, output, and communication interfaces.
Information on supported resolutions, standards, and power requirements.
Specifies operating temperature, humidity, weight, and dimensions.
To Next Page
