With the starter handle in its support, take the starter handle with your right hand and
pull slowly as far as to have a resistance, then pull energetically on the starter handle
with starter rope through the support. (If the cold start is not sufficient enough, repeat
this operation 2 or 3 times)
Immediately after the start, push back the choke lever from “CHOKE” position to
“RUN” position.(If the temperature is low, allow the engine to run for a few minutes
before starting to work.)
Operation The Controls For Mowing
Blade is in action as soon as engine started. While the machine is working maintain the
security handle in working position. The engine will stop as soon as you release the
engine control bar.
Release the lever to stop the engine whenever you need to leave the mower.
To Next Page
Loading...
