Feig Electronic ID PM ECCO+ - Wi-Fi Connectivity Setup

IDENTIFICATION
8 WiFi Connection
Page 14 of 14
Pos: 35 /I DP/ Man ual s/Ü bers chr ift en/1 /Wi -Fi Conn ecti on @ 3\ mod_1542017944279_10021.docx @ 55747 @ 1 @ 1
8 Wi-Fi Connection
WiFi Connection
Pos: 36 /I DP/ Man ual s/P ANMO BI L/Wi -Fi C on nec tion @ 3\mod_1542021824140_10021.docx @ 55998 @ @ 1
To connect Wi-Fi enabled devices to a host.
1. Connect the device to the host using the USB port and use the Master Setup to set the data output mode
to Wi-Fi.
2. Open the file “config.ini” setup the parameters for Wi-Fi and host connection (See the document
“Config_ini” section Wi-Fi to learn how to set the parameters for Wi-Fi communication).
3. Save the settings and disconnect the device from the computer.
4. The device tries to connect to the configured wireless network. The right LED (4) flashes blue every
second. If the device could connect to the wireless network and to the host, the right LED (4) flashes
slowly blue every 3 seconds.
If the device fails to connect, please check the parameters configured in the file “config.ini”. Ask your network
administrator for assistance if necessary.
Pos: 37 /S te uer modul e/------------ Seit enu mbruc h ------------ @ 0\mod_1452083281983_0.docx @ 10032 @ @ 1