9 Transmitting Data to a Host
Pos: 38 /I DP/ Man ual s/Ü bers chr ift en/1 /Tr ans mitti ng Bar cod e a nd/or RF ID D at a to a H ost @ 3\ mod_1542021992638_10021.docx @ 56007 @ 1 @ 1
9 Transmitting Barcode and/or RFID Data to a Host
Transmitting Data to a Host
Pos: 39 /I DP/ Man ual s/P ANMO BI L/Tr an smit ti ng B arco de a nd/ or R FID Dat a to a H ost @ 3\mod_1542022060134_10021.docx @ 56017 @ @ 1
Batch mode
All barcodes and RFID data scanned in batch mode are saved in the file “Output.txt” on the removable drive
“SCANNDY”. Connect the device to the host computer via USB and use the Windows-Explorer to navigate to
the device “SCANNDY”. Copy the file “Output.txt” to the host.
To delete the data from the device just delete the file “Output.txt”.
Transmitting data from a Bluetooth or Wi-Fi device
When the scanner is paired to a host via Bluetooth, the data transmits to the host after each scanning
procedure and is not stored on the scanner unless the scanner moves out of the range of the host. For out of
range usage you can configure the device to either store the data in a cache memory or do not allow
scanning.
If the device was configured to store the out of range captured data, it stores the data in a file Cache.txt.
After reconnection, it transmits all cached data to the host.
Bidirectional communication for Bluetooth and Wi-Fi connected devices
For applications that require bidirectional communication between the device and the host, PANMOBIL
devices support an embedded communication protocol SCOMP and REMOTE mode.
To Next Page
Loading...