Fein DDSk 111 - User Manual

\
DDSk 111
!o be handed to the workshop!
Operating instructions for the
Four Speed Electric Drill type DDSk 111 (3-phase A. C.)
and for DDSk 111 K (42 Volts)
1. Technical data
Type of current: 3-phase A. C.
Internal fuses for 220 Volts: 10 A (slow) or 15 A (fast)
Capacity
Morse Tap er Net
Type
in steel
Speed R. P.M.
Input
I
Outpa t socket of
weight
in.
I
mm
I I
420
DDSk 111
}
260
P /4 32
150
DDSk 111 K (42V)
100
2. Construction
The four speed drill DDSk 111 is an electric tool of class I with
earth wire. The sturdy air-cooled short-circuit motor run s nearly
without wear because of its low speed. The high voltage test is
made with the prescribed test vo ltage of 1500 Volts.
3. Connection and operation
Main voltage must correspond to the operating voltage marked
on the rating plate.
Before operating the tool for the first time check that the drill
shaft rotates correctly, i.e. in clockwise dir ection at all speeds.
Switch must be in the "Off" position when connecting.
The speed of the machine must only be changed at stand-still or
at slowing down without load. Release switch handle (54) of its
Watts
Watts
sp indle lbs
I
kg
I
960 650 3 28 12.6
4.
Maintenance
Before carrying out any maintenance work always remember
to pull out the plug.
Every 300 duty hours clean the tool of dust and dirt by blo wing
it out with dr y pneumatic air or by brushing.
In order to prevent accidents check cable and connections at
both sides at regular intervals .
After 900 duty hours the machine should be completely dis-
mantled as described under paragraph 6 and all parts should
be thoroughly cleaned. Rinse ball bearings and gears in clean
solvent and pack with fr e sh grease as per paragraph 5.
Please be sure that all electric and plastic parts are only cleaned
dry.
longitudinal position, put it across by turning it out, then push 5. Lubrication
it into the wanted switch direction and reset the switch handle We recommend to renew the gear grease after 300 duty hours .
in opposite direction again into its longitudin al position . Ple ase only use the Fein specia l grease FG 1. For ball and
BE 200/e X 7. 66 Printed in Germany Use Universal Gre?Jse type SSt 11
lnsteao of ot ; er types of grease!

Fein DDSk 111 Specifications