Need help?Do you have a question about the Felder KFS-37 and is the answer not in the manual?
General| Planer Width | 370 mm |
|---|---|
| Frequency | 50 Hz |
| Saw Blade Diameter | 315 mm |
| Voltage | 400 V |
| Type | Combination Machine |
| Motor Power | 4.0 HP (3.0 kW) |
Information on machine electrical connections, wiring diagrams, and operation.
Assembly, operation, and maintenance of the joiner-planer unit.
Assembly, operation, and maintenance of the tablesaw and slitting units.
Assembly, operation, and maintenance of the shaper unit.
Describes connecting the machine to the electrical supply and the operation of electrical components.
Description of the planer-thicknesser unit, its intended use, and technical specifications.
Guidelines for the correct and safe usage of the joiner-planer assembly.
Lists tasks that are explicitly forbidden on the joiner-planer assembly.
Procedure for safely replacing planer blades, emphasizing using only FELDER system blades.
How to adjust the feed table for thickness planing, including chip removal settings.
Recommended maintenance tasks and intervals to ensure longevity and precision.
Guidelines for the correct and safe usage of the tablesaw assembly.
Lists tasks that are explicitly forbidden on the tablesaw assembly.
Procedure for safely changing the sawblade, including speed and hole diameter requirements.
Guidelines for the correct and safe usage of the shaper assembly.
Lists tasks that are explicitly forbidden on the shaper assembly.
Procedure for quick insertion, removal, or exchange of the shaper spindle.
Instructions for shaping straight edges using the shaper fence.
Shaping edges or moldings that do not extend over the entire workpiece length.
Recommended maintenance tasks and intervals for the shaper assembly.
Instructions for adjusting and checking the belt tension for proper power transfer.
Guidelines for the correct and safe usage of the drilling assembly.
Lists tasks that are explicitly forbidden on the drilling assembly.
Critical safety information related to drilling operations.
To Next Page
