Need help?Do you have a question about the felfil evo and is the answer not in the manual?
General| Category | 3D Printers |
|---|---|
| Layer Height | 0.05 - 0.3 mm |
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, ABS, PETG, TPU |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Nozzle Temperature | Up to 260°C |
| Heated Bed Temperature | Up to 100°C |
| Layer Resolution | 0.05 mm |
To Next Page
