Need help?Do you have a question about the felfil evo and is the answer not in the manual?
General| Category | 3D Printers |
|---|---|
| Layer Height | 0.05 - 0.3 mm |
| Filament Diameter | 1.75 mm |
| Nozzle Diameter | 0.4 mm |
| Supported Materials | PLA, ABS, PETG, TPU |
| Connectivity | USB, SD Card |
| Frame Material | Aluminum |
| Nozzle Temperature | Up to 260°C |
| Heated Bed Temperature | Up to 100°C |
| Layer Resolution | 0.05 mm |
Details safe handling, material risks, and ventilation requirements.
Attaching the extrusion screw T8 to the gearmotor hub E1.
Securing the melting chamber T3 and teflon insulator T7 to the support.
Connecting the extrusion screw T8 to the gearmotor E1.
Inserting the thermocouple E9 into the melting chamber T3.
Attaching the nozzle T1 with the O-ring T2 to the melting chamber.
Inserting the heater cartridges T4 into the melting chamber T3.
Fixing the fan E2 to the lateral side C4.
Mounting the PCB E3 and display E4.
Attaching the encoder E5 and knob E6.
Securing the encoder block to the lateral side C3.
To Next Page
