37
User Interface 3
When the sceen below appears, it’s because Felfil Evo goes on protection mode. This
usually occours when the engine torque is too high, in order to avoid failure for engine and
mechanics.
Usually this is due to a too low temperature in the melting chamber, or a too high speed of
extrusion.
However when the block occurs, please set the temperature to 200°C, and wait about 20
minutes, to be sure that the material in the chamber is properly melted.
Press the knob, and you will be able to restart the process from “set tempereture”.
To Next Page
Loading...
