38
Usage
For a correct usage of Felfil Evo Complete Kit please follow these suggestions:
- Place it on a flat and stable surface before operating (a table is quite good);
- Do not place anything near Felfil Evo, it requires unrestricted airflow, for cooling,
proper operation and to protect the electronic components from overheating;
- Do not operate the machine for more than 4 hours. After that cycle, please could it down for
2 hours;
- The extruding screw must turn clockwise.
The first meters of filament will be dirty, and may have some metal shavings in it. Do not use
this filament in your 3D printer. Extrude all the pellets that were in the hopper, if filament still
looks dirty after this step, extrude more pellets to further clean the system.
Please pay attention:
- If the nozzle is not correctly tightened, plastic may exit, producing smell.
- If you recognise smell of burning plastic, immediately stop extrusion, open Felfil Evo and
check that everything is ok.
- If the cartridge heater seems to be ruined, please substitute with a brand new one, in order to
avoid any potential short-circuit.
If you have any problems using Felfil Evo filament extruder, contact support@felfil.com.
Felfil Evo needs some occasional maintenance:
when you have finished to extrude, empty the hopper leaving the filament extruder running
for few minutes.
Use always gloves while working on still hot components.
Remove the three nozzle screws only when these are cold.
?
Usage
?
Maintenance
To Next Page
Loading...
