18
14 TILE CUTTING ACCESSORIES
The manufacturer accepts no
responsibility caused by unsuitable
use or modifications.
The instructions for use and spare parts found in this document are for information only and are not binding. As part of
our product quality improvement policy, we reserve the right to make any and all technical modifications without prior
notice.
ANGLE GUIDE PROTRACTOR MITY MITRE GUIDE BULLNOSE FOLDING STAND
Parts List:
Diag. Part No. Qty. Description Diag. Part No. Qty. Description
1 050104 1 Frame, Miter 10 N/A- 1 Arm, Protractor
2 050107 1 Bar, Locking 11 020011 1 Carriage Bolt, 1/4-20 x 5/8”
3 050105 1 Clip, Stop 12 020244 1 Wing Nut, 1/4-20
4 050106 1 Spring 13 189737 1 Knob, 1/4-20 x 1”
5 050103 1 Knob, 1/4”-20 x 1” 14 051010 1 Protractor Assy
6 189737 2 Screw, Thumb, 1/4"-20 x 1" 15 020598 1 Screw, Thumb, 1/4"-20 x 1"
7 051020 1 Miter Assy, 45
° 16 051030 1 Holder Assy, Bullnose
8 189737 1 Knob, 1/4"-20 x 1" 17 051041 1 Stand, Tile Saw (for TA Models only)
9 N/A 1 Sector Plate 18 050102 1 Support Assy, Miter Frame
RIP GUIDE: P/N 051000 - The Rip Guide is a standard ac-
cessory supplied with every tile saw. It is used to
provide a repeatable position for rip cuts until relocated.
The Rip Guide clamps to the machined backstop of the
conveyor cart.
ADJUSTABLE PROTRACTOR: P/N 051010 - The
Protractor can be used to rip cut known angles. The
protractor clamps to the backstop.
ANGLE GUIDE : P/N 051020 - This is a non-adjustable mi-
ter used to quickly position the tile at 45 degrees; either
on the left or right side. It is often used for repeated
diagonal rip cuts. The Angle Guide clamps to the back-
stop.
BULLNOSE MITRE GUIDE: P/N 051030 -This is a fixed
guide that positions the tile for a 45 degree miter cut.
The Mitering Guide clamps to the backstop.
PRECISIN MITERING JIG: P/N 161480- This is a 45 degree
fixture that has an adjustable clamp to hold the tile while
miter cutting. The Mitering Guide clamps to the back-
stop.
FOLDING STAND: P/N 051041 - This stable, one piece stand
brings a FELKER® tile saw to standing level for ease of
work. The stand conveniently folds flat for storage and
transporting.
To Next Page
Loading...
