2
ENGLISH
CAPABILITIES
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
KEY
A. Paper/card entry
B. Shredder head
C. See safety instructions below
D. Bin
E. Window
F. Safety lock
G. Control switch and LEDs
1. Reverse
2. Off
3. Auto-On (white)
4. Overheat (red)
To set lock slide
button down
** Shredder will operate continously
for indicated time. Continous
operation beyond this time will
trigger a cool down period.
* 70g A4 paper at 220-240v, 50/60Hz, heavier
paper, humidity or other than rated voltage
may reduce capacity. Maximum recommended
daily usage rates: 30 sheets; 5 cards.
To learn more about Fellowes products and features go to www.fellowes.com
For safety reasons, shredder will operate only if the
shredder head is in correct position and used with
supplied basket.
LX10
Sheets Per Pass* 6
Cards Per Pass* 1
Maximum Continuous Operation** 3 min
Cool down Period** 30 min
Cut Size 4mm x 37mm
Current draw at capacity 1.0A
Entry Width 220mm
C.
A.
D.
F.
G.
E.
B.
Will shred: Paper, small paper clips, plastic credit cards and staples
Will not shred: CD/DVDs, Continuous forms, adhesive labels, transparencies, newspaper, cardboard, large paper clips,
laminates or plastic other than noted above
• Operation, maintenance, and service requirements are covered in
the instruction manual. Read the entire instruction manual before
operating shredders.
• Moving parts. Keep away from children and pets. Keep hands away
from paper entry. Always set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away
from shredder openings. If object enters top opening, switch to
Reverse ( ) to back out object.
• DO NOT use aerosol products, petroleum based or aerosol lubricants
on or near shredder. DO NOT USE “CANNED AIR” OR “AIR
DUSTERS” ON SHREDDER. Vapors from propellants and petroleum
based lubricants may combust causing serious injury.
• Sharp edges, DO NOT touch exposed cutting blades under shredder
head.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of
the voltage and amperage designated on the label. The plug on the power
supply cord is used as the disconnect device. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
• For indoor use only.
• Unplug shredder before cleaning or servicing.
To Next Page
Loading...
Need help?
General
