1
KEY
CAPABILITIES
ENGLISH
Model P-9C
Will shred: Paper, credit cards, paper clips and staples
Will not shred: Continuous forms, CD/DVDs, adhesive labels, transparencies,
newspaper, cardboard, laminates, file folders, X-rays or plastic other than noted
above
Paper shred size:
Cross-Cut ........................................................ 5/32 in. x 2 in. (3.9mm x 50mm)
Maximum:
Sheets per pass ...................................................................................................9*
Cards per pass .....................................................................................................1*
Paper entry width ......................................................................8 3/4 in. (225mm)
* 8.5 in. x11 in., 20lb., (75g) paper at 120V/60 Hz, 3.5Amps; heavier paper, humidity or
other than rated voltage may reduce capacity. Recommended daily usage rates: 10-20
paper passes; 10 credit cards. 9 sheets per pass.
Fellowes SafeSense
®
shredders are designed to be operated in home and office environments ranging
between 50 – 80 degrees Fahrenheit (10 – 26 degrees Celsius) and 40 – 80% relative humidity.
I. Control switch and LEDs
I 1. Auto-On (green)
O 2. OFF
R 3. Reverse
4. Overheat (red)
5. SafeSense
®
(yellow)
A. Shredder head
B. SafeSense
®
Technology
C. Paper/credit card entry
D. Window
E. Bin
F. Disconnect power switch
G. See safety instructions
H. Sheet capacity gauge
A.
G.
H.
I.
F.
C.
B.
D.
E.
• Keepawayfromchildrenandpets.Keephandsawayfrom
paper entry. Always set to off or unplug when not in use.
• Keepforeignobjects–gloves,jewelry,clothing,hair,etc.–
awayfromshredderopenings.Ifobjectenterstopopening,
switchtoReverse(R)tobackoutobject.
• Never use aerosol products, petroleum based lubricants or other
flammable products on or near shredder. Do not use canned air on
shredder.
• Donotuseifdamagedordefective.Donotdisassemble
shredder. Do not place near or over heat source or water.
• ThisshredderhasaDisconnectPowerSwitch(F)thatmustbeinthe
ON (I) position to operate shredder. In case of emergency, move
switch to OFF (O) position. This action will stop shredder immediately.
• Avoidtouchingexposedcuttingbladesundershredderhead.
• Donotputforeignobjectsinpaperentry.
• Thegroundedsocket-outletshallbeinstalledneartheequipmentand
shall be easily accessible.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
Breakthrough Safety Technology! SafeSense
®
stops shredding when hands are too close to the opening.
TO TEST SAFESENSE
®
TECHNOLOGY OPERATION
SET-UP AND TESTING
Press Auto-On (I) Touch test area and
look for the SafeSense
®
indicator to illuminate
Sensor lights up
1 2 3