Paper, credit cards, CD/DVDs, staples and small paper clips
Continuous forms, adhesive labels, transparencies, newspaper, cardboard,
large paper clips, laminates or plastic other than noted above
...................................................................................................
...........................................................................................................
.......................................................................................................
..................................................................................................
* A4 (70g), paper at 220-240V/50 Hz, 1.5Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Recommended daily usage rates: 500 sheets per day;
D. See safety instructions
H. Disconnect power switch
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Keep away from children and pets. Keep hands away from paper entry. Always
set to off or unplug when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair, etc. – away from shredder
openings. If object enters top opening, switch to Reverse (R) to back out object.
• Never use aerosol products, petroleum based lubricants or other flammable
products on or near shredder. Do not use canned air on shredder.
• Do not use if damaged or defective. Do not disassemble shredder.
Do not place near or over heat source or water.
• Operation, maintenance, and service requirements are covered in the instruction
manual. Read the entire instruction manual before operating shredders.
• This shredder has a Disconnect Power Switch (H) that must be in the ON (I)
position to operate shredder. In case of emergency, move switch to OFF (O)
position. This action will stop shredder immediately.
• Avoid touching exposed cutting blades under shredder head.
• Shredder must be plugged into a properly grounded wall outlet or socket of the
voltage and amperage designated on the label. The grounded outlet or socket
must be installed near the equipment and easily accessible. Energy converters,
transformers, or extension cords should not be used with this product.
• FIRE HAZARD – Do NOT shred greeting cards with sound chips or batteries.
BASIC SHREDDING OPERATION
switch in ON (I) position
after each pass to clear entry.
Continuous operation beyond
10-12-minutes will trigger
20-minute cool down period.
75Cs_406145_REVB_060111_UK.indd Sec4:2-Sec2:375Cs_406145_REVB_060111_UK.indd Sec4:2-Sec2:3 6/1/11 4:09 PM6/1/11 4:09 PM