ENGLISH
Models P-40/P-45C
Handle
Control switch
Sheet capacity gauge
Pivoting head
Bin
Easy emptying
CAPABILITIES
Will shred: Paper, credit cards and staples
Will not shred: Continuous forms, adhesive labels, transparencies,
newspaper, cardboard, paper clips, laminates or plastic other than
noted above
Paper shred size:
Strip-Cut ........................................................................................6.3mm
Cross-Cut .............................................................................. 3.9 x 50mm
Maximum:
Sheets per pass (Strip-Cut P-40) ............................................................8*
Sheets per pass (Cross-Cut P-45C) .........................................................6*
Cards per pass ........................................................................................1
Paper width .................................................................................. 229mm
Continuous operation ..............................................................5-7 minutes
* A4 (70g) paper at 220-240v,1.0 Amps; heavier paper, humidity or other than
rated voltage may reduce capacity. Recommended daily usage rates: 10-20
paper passes; 10 cards.
IMPORTANT SAFETY INSTRUCTIONS — Read Before Using!
• Avoid touching exposed blades under Cross-Cut shredder head. • The socket-outlet shall be installed near the equipment and shall be
easily accessible.
Auto-On (I)
Off (O)
Reverse (R)
2
To set lock, push
down and slide
Safety lock
Unlocked (green)
Locked (red)
Sheets per pass
See safety instructions below
• Keep away from children and pets. Keep hands away
from paper entry. Always unplug or set safety lock
when not in use.
• Keep foreign objects – gloves, jewelry, clothing, hair,
etc. – away from shredder openings. If object enters
top opening, switch to Reverse (R) to back out object.
• Never use aerosol, petroleum based or other flammable
products on or near shredder. Do not use canned air
on shredder.
• Do not use if damaged or defective. Do not open shredder
head. Do not place near or over heat or water source.
• 8 (P-40)/6 (P-45C) sheets per pass to avoid jams.