Fellowes Pulsar 300 - Steps to Bind; Binding Process Steps

ENGLISH
STEPS TO BIND
1 2
&J
Front
(over
Max IS
(80 gsm/20lb
Bock
(over
1. Punch front and back covers 2. Punch sheets in small
first. batches that do not overload
the machine or the user.
CORRECTING A BOUND DOCUMENT
Additional sheets may be included or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For best results empty the tray regularly.
STORAGE
lower the punch handle to the horizontal position. lower the lid. The Pulsar comb binder is designed to be stored horizontally on the desktop.
3. load punched sheets directly
onto the opened comb. Starting
with the front of the document.
4. When all punched sheets are
loaded onto the comb, push the
comb lever backwards to close
the comb and remove the bound
document.
4
http://www.monomachines.com
http://www.monomachines.com
ENGLISH
STEPS TO BIND
1. Punch front and back covers
first.
1
&J
Front
(over
Bock
(over
2
Max IS
(80 gsm/20lb
2. Punch sheets in small
batches that do not overload
the machine or the user.
3. load punched sheets directly
onto the opened comb. Starting
with the front of the document.
4. When all punched sheets are
loaded onto the comb, push the
comb lever backwards to close
the comb and remove the bound
document.
4
CORRECTING A BOUND DOCUMENT
Additional sheets may be included or removed at any time by opening and then closing the comb as previously described.
REMOVAL OF WASTE CLIPPINGS
The waste tray is located under the machine and is accessed from the right side. For best results empty the tray regularly.
STORAGE
lower the punch handle to the horizontal position. lower the lid. The Pulsar comb binder is designed to be stored horizontally on the desktop.