Fellowes SB-89CI - Basic Setup and Shredding Operation; Caster Installation; Paper or CD;Card Shredding; Jam Proof System Operation

BASIC SET UP AND SHREDDING OPERATION
CASTER INSTALLATION
1 2 3
1
1 2 3
2
1 2 3
3
1 2 3
4
1 2 3
5
AUTO
AUTO
AUTO
AUTO
AUTO
AUTO
2
Press ( ) ON to
activate (blue)
PAPER OR CD/CARD
1
To shred CDs rotate
CD flap into place
4
JAM PROOF SYSTEM OPERATION*
Eliminates frustrating jams by preventing overloads and powering through misfed paper.
Feed into paper entry
and release
If paper is misfed
and stops shredding,
all indicator lights
will illuminate and
shredder will pause for
3-6seconds
Shredder will take fewer sheets,
but if indicator is below yellow,
you can add more sheets without
fear of jamming
2
Increase the number of sheets
being fed up to the top yellow light
tomaximizeyourproductivity
If there is too much paper for
the shredder to power through,
it will reverse the paper out for
easy removal
Reduce paper quantity to an
acceptable amount and refeed into
paper entry
If too many sheets, indicator will
light up to red and shredder will
not take paper
Remove several sheets until the
indicator is below red and the
shredder will take the paper
Automatic correcting action
will power through the misfed
paper, so shredding can
continue (do not add more
paper during flashing)
3
2
3
2 3
1
3
3
Feed paper straight into
paper entry and release
1
3
Plug in and put
disconnect power
switch in ON (I) position
Continuous operation:
20-minutemaximum
NOTE: Shredder runs briefly
after each pass to clear entry.
Continuous operation beyond
20-minutes will trigger
40-minute cool down period.
HoldCD/cardatedge, 
feedintoCD/Cardflap 
entry and release
5
When finished
shredding set
to OFF (
)
6
2
2
* 100% Jam Proof when used in accordance with usesr manual
SET-UP AND TESTING MISFED PAPER
If Remove Paper icon ( ) is
illuminated, press reverse and
remove paper