support@femometerfamily.com
0504
24h
Fast 24HF oodS terilize
24h
Fast 24H Food Sterilize
Quick Warm-Up Function
Add 80 ml of puried water to the appliance. Avoid using tap
water as it produces limescale quickly.
Disconnect the appliance from the power source.
Pour out the water from the appliance.
Wipe the control panel and heating disc with a clean rag, then
store the appliance for future use.
Due to the high variety of textures in baby food, frequent mixing and temperature control
during defrosting are recommended.
Do not give milk/food to your child immediately after defrosting. Frozen milk or food should not
be heated directly.
Milk or food can be reheated after defrosting.
Note
Place the bottle with breast milk/milk on the anti-scald basket
and close the lid.
Press the "On/Off" button and "Fast" button to enter the fast-heating
function. Refer to the following table to set the time based on the initial
temperature of the bottle, its material, and the capacity of the breast
milk/milk. The screen will ash 3 times and then begin operation.
After setting the time, the screen will ash 3 times and then begin
working. The remaining working time will be displayed on the screen.
When the heating cycle is complete, the screen will ash "END" three
times and the appliance will enter standby mode. Carefully open the
lid and remove the bottle, which will be at a temperature of 36-41°C.
Remove the bottle with care.
How to Use Your Device?
1
6
2
3
4
24h
Fast 24HF ood Sterilize
5
2
4
h
F
a
s
t
2
4
H
F
o
o
d
S
t
e
r
i
l
i
z
e
7
8
!
English
Add Water:
Completion:
Unplug:
Drain Water:
Clean and Store:
Place the Bottle:
Activate Heating:
Monitor Time:
Fast 24 Sterilize
Food
Quick warm-up
Bottle type
Initial
temperature
Amount
of water
Amount of milk
60ml 120ml 180ml 240ml
Glass
4°C
80ml
3min 4min 5min 6min
20°C 2.5min 3min 4min 4.5min
Plastic
4°C 3min 4.5min 6min 7min
20°C 2.5min 3.5min 4.5min 5min
Fast 24 Sterilize
Food
24h
24h
To Next Page
Loading...
