support@femometerfamily.com
1110
The screen will display the current temperature. It will take about 30-
60 minutes to reach the target temperature.
1.Unplug the device after each use and before cleaning. Allow the device to cool down before
cleaning.
2.Drain any remaining water from the device.
3.If food has been heated in the device, make sure there are no leftovers on the bottom.
4.Wipe the casing and the inside of the heater using a soft damp cloth, then dry with a clean
cloth or paper towel.
Note: Do not use scouring sponges, abrasive cleaners, or any corrosive substances for cleaning.
Regular descaling every four weeks is recommended to ensure that the device functions
properly.
1. Pour 50 ml of white vinegar and 100 ml of cold water into the device.
2. Switch on the device and select the milk heating function. Let the device to run for 10 minutes.
3. Leave the solution in the device until the scale dissolves completely.
4. Unplug the device before draining it.
5. Drain the solution, ll the device with water, rinse thoroughly, and then empty it.
4
When the process is complete, the screen will ash "END" three
times and the appliance will enter standby mode. You can then open
the lid and remove the bottle.
24h
Fast 24HF ood Sterilize
5
Disconnect the appliance from the power source.
6
24h
Fast 24HF oodS terilize
24h
Fast 24H Food Sterilize
Pour out the water from the appliance.
Wipe the control panel and heating disc with a clean rag, then store
the appliance for future use.
2
4
h
F
a
s
t
2
4
H
F
o
o
d
S
t
e
r
i
l
i
z
e
7
8
Cleaning
Descaling
English
Monitor Temperature:
Completion:
Unplug:
Drain Water:
Clean and Store:
Note:
Descalers based on citric acid can also be used.
Do not use other types of descaler.
Disclaimer:The photos are for illustrative purposes only; the actual appearance of the
products may differ from those shown in the pictures.
Fast 24 Sterilize
Food
24h
!
To Next Page
Loading...
