N. IEC POWER SOCKET - Connect the supplied power cord
to a grounded AC receptacle in compliance with the
voltage and frequency ratings specified on the rear panel
of your amplifier.
O. PARALLEL SPEAKER OUTPUTS -
WARNING: In order to maintain the rated load impedance,
disconnect the internal speaker (400 Pro) before
connecting external speakers. See note below.
P. GROUND LIFT - Disconnects the LINE OUT {V} ground
connection (pin-1) which may reduce noise levels.
GROUNDED (normal) GROUND LIFTED
Q. LINE OUT - Balanced XLR jack for output to sound
reinforcement/recording equipment.
R. LINE OUT LEVEL - Adjusts the output
level of the LINE OUT jack.
S. PRE/POST EQ - Supplies the LINE OUT
jack with the signal either before or after it
is processed by the tone/equalization
circuits.
PRE (tone/EQ bypassed)
POST (tone/EQ active)
T. TUNER OUT - Connect your bass tuner to enable inline
instrument tuning (see MUTE {K}).
U. FOOTSWITCH - Connect the included footswitch to
enable remote on/off switching of the semi-parametric
equalizer. NOTE: When connected, the footswitch
overrides EQ ON/OFF {I} on the front panel.
V. EFFECTS - (1) Ef
fects Loop - Connect SEND to the input
of your effects device and the output of the effects device
to RETURN. (2) Multiple Pr
o™ Amps - Connect SEND on
the primary unit to RETURN on the auxiliary unit. The
primary unit controls all auxiliary units.
W. HORN LEVEL - (400 Pro only) Adjusts the
volume level of the horn (high frequencies).
X. FUSE - (400 Pro only) Protects the horn
from overload damage. If the horn stops
responding, replace the fuse with the same type and rating
as specified on your amplifier (2A, 250V).
NOTE: Safety Agencies in some countries have requirements
that prohibit a rating of less than 4-ohms for this product.
However, internal testing and consumer feedback have shown
this product to function reliably with various external speaker
enclosures. Fender
®
will warranty this product under normal
usage conditions with external speaker enclosures.
7
SS
SS
pp
pp
ee
ee
cc
cc
ii
ii
ff
ff
ii
ii
cc
cc
aa
aa
tt
tt
ii
ii
oo
oo
nn
nn
ss
ss
FF
FF
ee
ee
nn
nn
dd
dd
ee
ee
rr
rr
®®
®®
44
44
00
00
00
00
PP
PP
rr
rr
oo
oo
//
//
44
44
00
00
00
00
PP
PP
rr
rr
oo
oo
HH
HH
ee
ee
aa
aa
dd
dd
wwwwww
..
ffeennddeerr..ccoomm
✧
wwwwww
..mmrrggeeaarrhheeaadd..nneett
TYPE: PR 412
PART NUMBERS 400 PRO: 2245500010 (120V, 60Hz) USA 2245503010 (240V, 50Hz) AUS 2245504010 (230V, 50Hz) UK
2245506010 (230V, 50Hz) EUR 2245507010 (100V, 50-60Hz) JPN 2245509010 (220V, 60Hz) ROK
400 PRO HEAD: 2245600010 (120V, 60Hz) USA 2245603010 (240V, 50Hz) AUS 2245604010 (230V, 50Hz) UK
2245606010 (230V, 50Hz) EUR 2245607010 (100V, 50-60Hz) JPN 2245609010 (220V, 60Hz) ROK
POWER REQUIREMENT: 900W
PREAMP INPUT IMPEDANCE: PASSIVE: 1MΩ ACTIVE: 1MΩ
SENSITIVITY AT FULL POWER: PASSIVE: 19mV ACTIVE: 40mV
NOMINAL LEVEL: PASSIVE: 145mV ACTIVE: 300mV
POWER AMP SENSITIVITY: 1.4V R.M.S., 1kHz
POWER OUTPUT: 350W R.M.S. into 4Ω @ < 0.02 % T.H.D., 1 kHz
TONE CONTROLS ROOM BALANCE: ±10dB, crossover frequency: 350Hz
BASS/TREBLE: BASS: ± 15dB @ 50Hz TREBLE: ± 15dB @ 10kHz
SEMI-PARAMETRIC EQ: LOW FREQ: 25Hz to 150Hz LOW LEVEL: ±15dB @ LOW FREQ setting
MID FREQ: 140Hz to 1.6 kHz MID LEVEL: ±15dB @ MID FREQ setting
HIGH FREQ: 1.4kHz to 8kHz HIGH LEVEL: ±15dB @ HIGH FREQ setting
EFFECTS LOOP IMPEDANCES: SEND: 1kΩ RETURN: 22kΩ
NOMINAL LEVEL: +4dBu (adjustable with level control)
FOOTSWITCH: One button: EQ (0055852000)
SPEAKERS: 2 Eminence
®
8Ω 10" woofers
(0057982000)
, 1 Foster
®
8Ω horn
(0048847000)
FUSE: 2A, 250V
DIMENSIONS 400 PRO: HEIGHT: 24 3/4 in (62.9 cm) WIDTH: 23 in (58.4 cm) DEPTH: 17 in (43.2 cm)
400 PRO HEAD: HEIGHT: 7 in (17.8 cm) WIDTH: 23 1/16 in (58.6 cm) DEPTH: 15 1/2 in (39.3 cm)
WEIGHT 400 PRO: 80 lb (36.4 kg)
400 PRO HEAD: 42 lb (19.1 kg)
Product specifications are subject to change without notice.
To Next Page
Loading...
