Need help?Do you have a question about the Fender ’59 BASSMAN and is the answer not in the manual?
General| Type | Tube Amplifier |
|---|---|
| Output Power | 45 Watts |
| Speakers | 4 x 10" Jensen P10R |
| Preamp Tubes | 3 x 12AX7 |
| Rectifier Tube | 1 x 5AR4 |
| Controls | Presence, Bass, Middle, Treble |
| Dimensions | 10.5" |
| Weight | 53 lbs (24 kg) |
| Channels | 2 (Normal, Bright) |
| Inputs | 4 (2 x Instrument, 2 x Mic) |
Protects amplifier from electrical faults. Replace with correct type and rating.
Switches the amplifier ON and OFF.
Puts amp in standby mode to extend tube life and reduce warm-up time.
Illuminates when the amplifier is ON and receiving power. Bulb may need replacement if not lit.
Adjusts ultra-high frequency level for added high-end sparkle.
Adjusts the middle-frequency level.
Adjusts the low-frequency level.
Adjusts the high-frequency level.
Adjusts the loudness of the bright channel.
Adjusts the loudness of the normal channel.
Connection for electric guitar, provides extra treble boost and higher gain.
Connection for electric guitar, provides heavier tone and lower gain.
Model type of the amplifier.
Part numbers for different regional variants of the amplifier.
Physical dimensions (height, width, depth) and weight.
Amplifier's power output rating in Watts RMS at a specified THD.
Input impedance for channel 1 and channel 2.
Amplifier's output impedance in Ohms.
Voltage, frequency, and power consumption for different versions.
List of vacuum tubes (original and alternatives) used in the amplifier.
Description of the speakers, including size and materials.
To Next Page
