If the amp is set up but does not
function, check the following items:
• Is the power cord properly plugged into an
electrical outlet?
• Is there power at the outlet?
• Are all the control knobs turned above 0?
• Is the volume control on the instrument turned up?
• Is the instrument properly plugged into the
amplifier?
(Eliminate any effects pedals and try using another cord . )
If after checking all of the above your amplifier is still
not performing correctly, consult your authorized
Fender Service Center.
The exclusive covering on your
Fender Automatic cabinet has been
especially designed for years of
lasting beauty. A very light soapy
solution on a sponge may be used to
remove dirt and residue that may
accumulate in the fabric. Be careful not to let any
liquid come in contact with operating surf a c e s .
REMEMBER TO UNPLUG THE POWER CORD
BEFORE CLEANING AND WAIT UNTIL THE UNIT
IS COMPLETELY DRY BEFORE PLUGGING IT IN.
TROUBLESHOOTING COVERING CARE
6
To Next Page
Loading...
Need help?
General
