PC
SECTION 3 – SENDING PRESETS FROM A PC TO THE G-DEC
Sending a preset from the PC to the G-DEC.
Please be sure that you backup all of your presets before you try the next two steps.
Transferring a preset from the PC to the G-DEC is very simple. In the MIDI-OX “Sysex view and
scratchpad “ window, select “File / Send Sysex File.” You will be prompted for the name of a preset file.
Choose a file with a single preset in it. This would be a function created by the DUMP PRST function.
Then press the OPEN button in MIDI-OX. A progress bar will appear and show your preset being loaded
to the G-DEC. When complete, the G-DEC will ask you to select a user storage position in which to store
the preset. Rotate the large preset selection knob to select which preset location to store the newly loaded
preset. Then press the G-DEC SAVE button.
Sending all of the G-DEC preset from the PC to the G-DEC.
The procedure for sending all of the G-DEC presets from the PC to the G-DEC is similar to the above step.
In the MIDI-OX “Sysex view and scratchpad “ window select “File / Send Sysex File”. You will be
prompted for the name of a preset file. Choose a file that was created using the DUMP ALL function, then
press the OPEN button in MIDI-OX. A progress bar will appear and show your presets being loaded to the
G-DEC. The G-DEC LCD will show a “LOADING PRESETS” message. Once the loading is finished the
G-DEC will return to normal mode.
To Next Page
Loading...
