Need help?Do you have a question about the Fender Passport PD250 Plus and is the answer not in the manual?
Plug your microphone in here. This three pin XLR balanced female input connector is intended for input signals from low impedance microphones.
Plug your instrument in here. This 1/4" balanced input jack is suited for use with items having a line level output such as high impedance microphones, keyboards, drum machines, outboard effects, etc. It accepts both balanced and unbalanced cables.
The Stereo phono (RCA) input jacks designed for use with a tape player, CD player, MP3 player, DAT player or any other stereo source.
This stereo (1/4") input jack is wired for Tip=Left, Ring=Right and Sleeve=Ground, the standard format of commercially available cables.
The Stereo Out RCA jacks provide an output mix that is independent of the Master Level Controls. Connect these to the inputs of a recording device.
The footswitch connector allows the internal reverb return to be muted, or shut off, through the use of a simple foot operated switch.
Plug the output of your external effects signal processor in here. This 1/4" input stereo jack is designed to accept signals from an external processing device.
Plug your external effects signal processor in here. This 1/4" output jack is designed to feed the Passport's effects bus signal to an external signal processing device.
Each channel of the amplifier has a Send {A} and Return {B} jack. These jacks provide a point to patch in an equalizer, or other processor into the sound system.
These are speaker level (powered) output jacks designed to feed each of your Passport speaker enclosures. Use the enclosed cables to connect the Passport's speakers.
The Passport is equipped with a grounding type IEC supply cord to reduce the possibility of shock hazard. Be sure to connect it to a grounded AC receptacle.
Turns the AC power ON and OFF. When the switch is in the OFF position, your Passport is completely shut down.
Turn the Power Switch to the ON position. The Power LED {A} will illuminate green and the Protect LED {B} will flash red and the system will turn on.
General| Type | Portable PA System |
|---|---|
| Channels | 2 |
| Built-in Effects | Reverb |
| Power Output | 250W |
| EQ | 3-band EQ |
| Power Supply | AC |
| Inputs | 4 XLR-1/4" combo inputs, 2 RCA inputs, 1/8" stereo aux input |
To Next Page
