Fender Speaker User Manual

Your new Acoustasonic™ Ultralight stereo loudspeaker features two 8"
(20.3 cm) Eminence® woofers with neodymium magnets and two 1"
(2.5 cm) soft dome tweeters with neodymium magnets, handling
up to 250 watts of power. Designed to complement the Fender®
Acoustasonic™ Ultralight amplifier, the Ultralight speaker cabinet is
constructed from quality Italian poplar plywood. Please read these
instructions and your amplifier manual before making connections.
Ultralight Connections
To connect the Acoustasonic™
Ultralight speaker to an Ultralight
amplifier, use the Speakon® cable
included with the amplifier. Rotate
the Speakon® connector to align it
with the input slots, then fully insert
the connector.
Rotate the connector clockwise until it
locks into place.
Disconnecting
Slide the locking tab back on the
connector while rotating the connector
counter-clockwise. Pull the connector out
from the input socket.
Non-Speakon® Connections
If your amplifier does not have a
Speakon® speaker output, you will need
the appropriate speaker cable or adapter
to connect the Acoustasonic™ Ultralight
loudspeaker. Speaker cable should be
4-conductor, 18–gauge minimum with
the Speakon® connector wired:
1+ pin = Right [+]
1– pin = Right [–]
2+ pin = Left [+]
2– pin = Left [–]
SPECIFICATIONS
PART NUMBER 2271700000
SPEAKERS Two 8" (20.3 cm) drivers with 2" (5.1 cm) voice coils
and Neodymium magnets;
Two 1" (2.5 cm) soft dome tweeters
with Neodymium magnets
CROSSOVER
3kHz, 12dB/octave low-pass filter, 18dB/octave high-pass
filter, using metallized polyester film capacitors and
low loss inductors
CABINET 5/8" (1.6 cm) Italian poplar plywood
SENSITIVITY 91 dB, 1 watt - 1 meter
POWER HANDLING 125 watts per side
IMPEDANCE 4 ohms per side
CONNECTIONS 4-Pole Speakon® connector
ENCLOSURE VOLUME V
B = 0.43 ft
3
(12 L) per side
DIMENSIONS
Height: 15 in (38.1 cm)
Width: 20.25 in (51.4 cm)
Depth: 10 in (25.4 cm)
WEIGHT 22 lb (10.0 kg)
Product specifications are subject to change without notice.
A PRODUCT OF:
FENDER MUSICAL INSTRUMENTS CORPORATION
CORONA, CALIFORNIA USA
Fender
®
and Acoustasonic™ are trademarks of FMIC.
Other trademarks are property of their respective owners.
© 2005 FMIC. All rights reserved.
P/N 069327 REV A
FENDER
®
ACOUSTASONIC
™
ULTRALIGHT STEREO LOUDSPEAKER ENCLOSURE

Fender Speaker Specifications

General

Brand	Fender
Model	Speaker
Category	Speakers
Language	English

Summary

Ultralight Connections Guide

Connecting Ultralight Speakers

Instructions for connecting the Acoustasonic™ Ultralight speaker to an amplifier using the Speakon® cable.

Disconnecting Ultralight Speakers

Steps to safely detach the Speakon® connector from the input socket by releasing the locking tab.

Non-Speakon Connections

Non-Speakon Speaker Wiring

Guide for connecting the speaker using a 4-conductor, 18-gauge cable if the amplifier lacks a Speakon® output.

Acoustasonic Ultralight Specifications

Part Number

The specific identification number for the Acoustasonic™ Ultralight stereo loudspeaker enclosure.

Speaker Drivers

Details on the 8" woofers and 1" soft dome tweeters, including neodymium magnets.

Crossover Specifications

Technical details of the crossover including frequency and filter slopes.

Cabinet Material

Information on the construction material of the speaker cabinet.

Sensitivity

Loudspeaker sensitivity rating, measured in dB at 1 watt and 1 meter.

Power Handling

The maximum power handling capacity of the loudspeaker, specified per side.

Impedance

Electrical impedance of the loudspeaker, specified per side.

Connector Type

The type of speaker connector used on the Acoustasonic™ Ultralight enclosure.

Enclosure Volume

The internal volume of the loudspeaker enclosure, provided in cubic feet and liters per side.

Dimensions

Physical dimensions of the loudspeaker enclosure: height, width, and depth.

Weight

The total weight of the loudspeaker enclosure, including metric conversion.