FUSION
™
1x / 2X
MADE IN THE U.S.A
1
Product Type:
Mode 2
Mode 2
Flash Pattern
Flash Pattern
Mode 1
Mode 1
Hardwire Option:
To operate the hard wire option, connect the black, 12V(-) wire to ground
and the red, 12V(+) wire to an activated switch. To change patterns, tap
the green ash pattern changer wire to the 12V(-) ground wire. To activate
mode 2, connect the white wire to an activated 12V(+) switch.
Single Color
Dual Color
1X
2X
Mounting Specications:
Make sure the suction cups have been cleaned with alcohol to remove
all residue.
Stick lights onto the interior of the vehicle dash window.
Color Specications:
A R B W G
RW BW AW RB AR AB
Optic:
40 180
Cigarette Plug Option:
To operate the cigarette plug option, plug in the provided lighter plug into
the vehicle's cigarette lighter plug outlet. Turn the unit on with the On/O
switch and change patterns with the momentary ash pattern changer.
Wiring Type:
Hardwire Cigarette Plug
12V
Red/Mode 1
White/Mode 2
Green/Pattern Changer
Black/Ground
+
Alternate Light Heads:
For the light heads to alternate, one light head must be set as master
and the other as slave on the mode wire intended for use. To do so,
hold the blue (ash pattern changer) wire to ground for 3 seconds.
For Single color: if all LEDS turn on this indicates master mode. If no
LEDS turn on this indicates slave mode.
For Dual color: if all LEDS turn on this indicates master mode. If half of
the LEDs turn on this indicates slave mode.
To Next Page
Need help?
General