Ferm CRM1045 - Environmental and Warranty Information

9
EN
Replacing/topping up oil
The compressor has been supplied with synthetic
oil“SAE10W30”.Itisrecommendtofully
replace the oil of the pump system within the first
100 operating hours.
• Unscrewthedrainplug(gauge)(13)onthe
sumplid,letalltheoilrunoutandscrewback
the plug (fig. 17).
• Filltheoilviatheupperholeofthesumplid
(fig.18) until the level indicated on the gauge
(13) (fig. 8) has been reached.
Checktheoillevelofthepumpsystem
every week and if necessary top up.
The synthetic oil has the advantage that it
does not lose its characteristics, either in
summer or in winter periods.
Forreplacementofoilthetablebelowshouldbe
adhered to.
type Operating hours
Multigrade oil SAE 10W30 100 or 6 months
Faults
Shouldafaultoccur,e.g.afterwearofapart,
please contact the service address on the
warrantycard.Inthebackofthismanualyoufind
an exploded view showing the parts that can be
ordered.
ENVIRONMENT
Topreventdamageduringtransport,the
appliance is delivered in a solid packaging which
consists largely of reusable material.
Therefore please make use of options for
recycling the packaging.
Faulty and/or discarded electrical or
electronic apparatus have to be collected
at the appropriate recycling locations.
WARRANTY
The warranty conditions can be found on the
separately enclosed warranty card.