To Next PageTo Next Page
Need help?Do you have a question about the Ferm FVM-250 and is the answer not in the manual?
Ensure the switch is off before plugging in to avoid accidental start.
Use only three-core earthed extension cables suitable for the tool's power input.
Ensure dust extraction system is connected and used when available for health and safety.
Use only recommended accessories to avoid personal injury risks.
Check voltage, plug, lead, abrasive type, and run idle to detect faults before use.
Press the trigger switch to turn the sander on.
Press the trigger switch while depressed to enable continuous operation.
Rotate the adjusting wheel to set the desired speed for the job.
Use dust collection items and a mask for fine dust. Keep ventilation slots clear.
Switch off and unplug. Clean with a soft brush; avoid water or flammable liquids.
Switch off immediately for damaged cable, defective switch, or smoke.
Only qualified experts should repair electrical appliances to ensure user safety.
Follow wire colours (Blue, Brown, Yellow/Green) for correct connection to terminals.
Secure wires firmly, use the cord grip, and fit a 5-amp fuse.
General
