To Next PageTo Next Page
Need help?Do you have a question about the Ferm BS-702 and is the answer not in the manual?
General| Input power | 280 W |
|---|---|
| No-load speed | 6000-11000 RPM |
| Sanding paper size | 125 mm |
| Dust extraction | Yes |
| Power | 280 W |
| Orbit diameter | 2.5 mm |
| Sandpaper size | 125 mm |
| Weight | 1.5 kg |
| Power source | Electric |
| Sanding paper attachment | Velcro |
Check voltage, mains lead, and plug condition before initial use.
Take precautions before operation, such as using safety goggles and a dust mask.
Identification of key machine parts and components as shown in Figure 1.
Step-by-step guide for assembling the machine's main components.
Guidance on selecting different grits of sandpaper for various tasks.
Instructions on how to correctly mount the sanding belt onto the rollers.
Information about the sanding disc and its adhesive plates.
How to position the sanding belt vertically for increased flexibility.
Ensure motor ventilation slots remain clear of dirt to prevent overheating.
Transport rollers of the machine do not require lubrication.
Addresses potential causes and solutions when the motor overheats.
Diagnoses issues when the machine fails to operate after being connected.
