8
EN
does not come off use a soft cloth moistened with
soapy water. Never use solvents such as petrol,
alcohol, ammonia water, etc. These solvents may
damage the plastic parts.
Troubleshooting
Please find some potential causes and solutions
to possible failure.
1 The operating switch is switched on, but
the motor is not working
• The electric circuit is broken
• Have the electric circuit repaired
• Wires in the mains plug or in the socket are
loose
• Have socket and plug checked or repaired
• The switch is faulty
• Have the switch repaired
• Carbon brushes are worn
• Replace the carbon brushes
2 Router runs slowly
• Variable speed set low
• Increase variable speed
• Motor is overloaded
• Reduce pushing force on router
3 Excessive vibration
• Bent cutter shank
• Replace cutter
Faults
Should a fault occur, e.g. after wear of a part,
please contact the adress on the warranty card.
Included you find an exploded view showing the
parts that can be ordered.
ENVIRONMENT
In order to prevent the machine from damage
during transport, it is delivered in a sturdy
packaging. Most of the packaging materials
can be recycled. Take these materials to the
appropriate recycling locations.
Faulty and/or discarded electrical or
electronic apparatus have to be
collected at the appropriate recycling
locations.
WARRANTY
The guarantee conditions can be found on the
separately enclosed guarantee card.
The product and the user manual are subject
to change. Specifications can be changed
without further notice.
To Next Page
Loading...
Need help?
General