Why is the paint pattern tailing with my FERREX 808470 Paint Sprayer?
Tailing in the paint pattern can occur due to several reasons: * The pressure might be too low, so increase the pressure. * The gun or the suction pipe filter is plugged, so clean the filters. * The suction pipe is loose at the suction pipe inlet port, so tighten the suction pipe fitting. * The spray tip is worn, so replace it. * The paint is too thick, so thin the paint.
What to do if FERREX Paint Sprayer draws up paint but the pressure drops when the gun is triggered?
If your paint sprayer draws up paint, but the pressure drops when triggering the gun, consider the following: * The spray tip may be worn, so replace it with a new one. * The suction pipe filter may be clogged, so clean it. * The gun filter may be plugged, so clean or replace it, keeping extra filters handy. * The paint may be too heavy or coarse, so thin or strain it. * The suction pipe inlet port may be damaged or worn, so replace the inlet valve. * The suction pipe may be loose, so tighten it.
What to do if my FERREX Paint Sprayer gun will not spray?
If the spray gun doesn't spray, it might be because the spray tip or the gun filter is plugged, so clean them. Alternatively, the spray tip might not be fully in the SPRAY position, so put the tip in the SPRAY position.
What to do if the tip guard assembly leaks on my FERREX 808470?
If the tip guard assembly is leaking, make sure the tip was assembled correctly, and assemble it properly. If the washer is worn, replace it.
Why is there flow through the return tube when the PRIME/ SPRAY switch is on SPRAY on my FERREX 808470 Paint Sprayer?
The PRIME/SPRAY switch may be dirty or worn.
Why is my FERREX 808470 gun leaking?
Internal parts of the gun may be worn or dirty.
Specifies that this product is for private domestic DIY use only and not for commercial trade.
Guidelines for maintaining a safe and well-lit work area, avoiding explosive atmospheres, and keeping children away.
Precautions regarding power tool plugs, earthed surfaces, exposure to rain or wet conditions, and cord usage.
Advice on staying alert, using PPE, preventing unintentional starting, and proper attire.
Instructions on not forcing the tool, using it correctly, disconnecting power, storing properly, and maintenance.
Emphasizes using qualified repair persons and only identical replacement parts for safety.
Step-by-step guide for connecting the high pressure hose to the spray gun using supplied wrenches.
Instructions for attaching the extension lance to the spray gun for extended reach.
Instructions on how to lock and unlock the spray gun trigger for safety.
Procedure for priming the pump by circulating paint through the system.
Steps for performing the actual spraying operation after priming.
Essential steps to safely relieve pressure from the system before maintenance or storage.
Detailed instructions for cleaning the spray station after use to prevent damage and maintain warranty.
Specific steps for removing and cleaning the suction pipe filter.
Procedure for disassembling and cleaning the spray gun components.
Highlights the importance of thorough daily cleaning and lubricating after use.
Mentions that pump parts may wear and require replacement; refers to troubleshooting.
Instructions for preparing and storing the unit to prevent damage and blockages.
Guidance on proper disposal of paint waste and materials to protect the environment.
Explains the coverage and support provided under the 3-year warranty.
General| Brand | FERREX |
|---|---|
| Model | 808470 |
| Category | Paint Sprayer |
| Language | English |
To Next Page