What to do if my FERREX Rotary Hammer drill won't start?
If your FERREX Rotary Hammer drill doesn't start, it might not be properly connected to the mains. Ensure the mains plug is fully inserted into the socket. Also, check the mains plug and cord for any damage; if damaged, have them replaced by a qualified workshop.
Why is my FERREX Rotary Hammer tool/chuck not rotating?
If the tool or chuck on your FERREX Rotary Hammer isn't rotating, the selector switch may not be set correctly. Press the release button and turn the selector switch to the symbol indicating 'Drilling without the hammer function' or 'Hammer drilling'.
What to do if the chisel on my FERREX Rotary Hammer is rotating?
If the chisel on your FERREX Rotary Hammer is rotating when it shouldn't be, it means chiselling mode has not been selected. Press the release button and turn the selector switch to the symbol indicating 'Chiselling'.
General| Voltage | 230-240V |
|---|---|
| Input Power | 1500W |
| Chuck Type | SDS-Plus |
| Drilling Capacity in Concrete | 32 mm |
| Drilling Capacity in Steel | 13 mm |
| Drilling Capacity in Wood | 40 mm |
| No Load Speed | 800 rpm |
| Power Source | Corded Electric |
| Impact Rate | 3900 bpm |
| Impact Energy | 5 Joules |
To Next Page