FERREX PSI30 - Pack Contents and Parts

MODEL No.: TGT2001, PRODUCT No.: 70096
Congratulations on the purchase of your FERREX® 30W Wood Burning Kit when
you open your packaging, rst remove all items and check there are no parts
damaged or missing. If you nd anything wrong, do not operate the product
until the parts have been replaced or the fault has been rectied. Failure to do so
could result in serious personal injury.
Application
First time users or inexperienced operators pay particular attention to the
operation of the 30W Wood Burning Kit, including details of starting and
stopping and correct use of the 30W Wood Burning Kit on page 8, as well as the
maintenance instructions on page 11.
Intended use of the 30W Wood Burning Kit
It is exclusively intended for home use. It is not designed for trade or commercial
use.
This 30W Wood Burning Kit, hereafter refered to as device, can be used to quickly
and permanently brand decorative and markings onto wood, leather, cork, paper
mache, smooth fabrics, thin plastic materials, candle wax and other materials or
to remove parts of their surfaces. The comprehensive range of tips and stamps
supplied can also be used for soldering when tted with the corresponding
tip. Any other use or change to the appliance is deemed improper and poses a
signicant risk of accidents.
Contents of carton
1 x 30W Wood Burner
10 x Wood Burning Drawing Tips
9 x Wood Burning Stamping Patterns
1 x Solder Tip
1 x Hot Knife Blade
1 x Hot Knife Collet
1 x Safety Stand
1 x ABC/123 Template
1 x Carry Case
1 x Instruction Manual
1 x Warranty Card & details
Pack contents / parts
2