FERRI MT Series - Page 15

MT Owners Manual
4.2.2 The slot for the pin of the top link allows the shredder to follow any small depressions
on the ground. In case of particularly uneven fields or steep slopes, it is advisable to
replace the fixed top link with a chain (See Figure 17).
Figure 17
13
4.2.3 Completely lift the shredder and check that the tractor is stable.
Add ballast to the front of the tractor if the front of the tractor is too light (Figure 18).
4.3 ATTACHING THE PTO SHAFT
4.3.1 With the hydraulic lift of the tractor, place the shredder to the closest point between
the two power takeoffs and check the minimum length of the PTO shaft (Figure 19).
IF it needs lengthening, check that the overlap is not less than 2/3 of L (Figure 20).
IF it needs shortening, proceed as in (Figure 8).
Figure 18
Figure 19
Figure 20