FERRI MT Series - Page 16

MT Owners Manual
4.3.2 The guards of the PTO shaft must be fixed to the shredder
and to the tractor with chains to prevent rotation.
4.3.3 The minimum overlap of the guard and the PTO shaft must
be at least 2 in.
(Figure 13).
4.4 Assembling the Separate Components (Variations):
4.4.1 Assmbling the Rake: (only on rear version machines)
To assemble the rake proceed as follows: (Figure 22)
If the rear bonnet is fitted (7) (Figure 13), unscrew and take it away.
Move the roller as far as possible from the rotor, fixing the screws in the position B.
Fix the rake holder (1) using the special screws (2). Insert the rake and set the height
of cut using the spring pins (4).
NOTE: If the rake is fitted on a machine equipped with wheels instead of the roller, fix the
guard (5) under the rake holder (1), making the necessary holes while assembling
the guard. (Figure 23)
Figure 21
Figure 22
14
Figure 23