Need help?Do you have a question about the Ferris IS700ZB2761 and is the answer not in the manual?
General| Transmission | Hydro-Gear ZT-3400 |
|---|---|
| Weight | 1, 050 lbs |
| Engine | Briggs & Stratton |
| Fuel Capacity | 10 gallons |
| Spindle Material | Cast Iron |
| Cutting Width | 61 inches |
| Cutting Height | 1.5 - 5 inches |
| Speed | 10 mph |
A checklist of essential setup tasks to prepare the unit for customer delivery.
Procedure to verify and tighten mower blade mounting bolts to specified torque.
Procedure to check and adjust the timing of the deck lift rods.
Steps to determine and adjust the mower deck for proper leveling.
Procedure to check and adjust the tensioning spring length for the drive belt.
How to set the mower deck cutting height using the adjustment pin.
Procedure for starting a carbureted engine, including choke and throttle settings.
Tests for functional and safety interlock systems to ensure proper operation.
Critical steps to remove air from the hydraulic system for efficient operation.
To Next Page