tain cases, this can take a few sec
onds).
► Press the connection button on the
mobile dust extractor or on the re
mote control once.
The LED on the retrofit receiver
module slowly flashes blue and the
mobile dust extractor is ready for
connection for 60 seconds.
► Switch on the cordless power tool.
The mobile dust extractor starts up
and the battery pack is connected
until the mobile dust extractor is
manually switched off.
If a second battery pack is con
nected to the mobile dust ex
tractor, the connection to the
first battery pack is lost.
Switching the mobile dust extractor on
and off
Once you have connected the battery
pack with the mobile dust extractor, the
mobile dust extractor will start up auto
matically when the cordless power tool
is in use.
After the mobile dust extractor
has been switched off via the
battery pack, it will continue to
run for up to fifteen seconds.
► Press the on/off switch on the cord
less power tool to switch on the mo
bile dust extractor.
► Release the on/off switch on the
cordless power tool to switch off the
mobile dust extractor.
English
34
To Next Page
Loading...
