cial setup before use. However, some components may be
shipped inside the canister and need to be removed before
use, and the collection bag needs to be installed.
elease the latches and lift the motor housing off the
canister, as described below.
emove any components from the canister.
and undamaged from shipping. (See
Power Cord Bracket
Collection bags make the disposal of dust and dirt easier,
page 10
for dust liner installation.)
elease the 2 latches that hold the motor housing to
the collection canister, and lift the motor housing off the
During replacement, make sure the motor housing
is squarely seated on the canister before closing the
The motor housing contains a sealing gasket for the
canister. Periodically inspect the gasket for tears or
A
B
Latch
Motor
Housing
Collection
Canister
o install the collection bag in a CT-Mini or CT-Midi:
To install the collection bag in a CT-Mini or CT-Midi:T
Unfold the bag and place it in the bottom of the collec-
tion canister.tion canister
dust from escaping during disposal.
Bag Latches
Bag
Flange
Dust Flap
vacuum inlet, and release the bag latch.
A
B
Bag Latch
C
Bag
Flange
Vacuum
Inlet
To prevent dust from escaping the bag during disposal,
you can close the bag’s dust gate by pulling out on the
Don’t close the dust gate on an unused bag.
The dust gate cannot be easily reopened once closed.
Upper
Tab
Dust Gate
e sure the bag is not pinched between the canister
and motor housing, and replace the motor housing.
To Next Page
Loading...
Need help?
General
