Festool CTM 26 E - Page 17

7.7 Changing the filter bag (SC FIS-CT
26/36/48)
Removing the filter bag [4]
► Open the locking clips [2-2] and remove the
top section of the machine[2-1].
► Remove the filter bag.
► Dispose of the used filter bag in accordance
with statutory regulations.
► Clean the dust container [2-3].
Inserting the filter bag [5]
► Insert a new filter bag (SC FIS-CT 26/36/48)
in the inlet port of the dust container and in
terlock it. Important: be aware that the
locking engages.
► Replace the top section [2-1] and close the
locking clips [2-2].
Make sure that the filter bag is not
pinched between the top and bottom
sections.
7.8 Changing the disposal bag
Removing the disposal bag [6]
► Close off the extractor opening [1-2] using
the sealing plug [1-1].
► Open the locking clips [2-2] and remove the
top section of the machine [2-1].
► Close the disposal bag.
► Remove the disposal bag.
► Dispose of the used disposal bag in accord
ance with statutory regulations.
► Clean the dust container [2-3].
Inserting the disposal bag [7]
► Insert a new disposal bag (ENS-CT26/36/48)
on the inlet nozzle of the container and lock
in position.
Important: The lateral openings on the dis
posal bag must be positioned inside the
container. Make sure that the bolt engages.
► Place the disposal bag over the edge of the
container.
Make sure that the contacts [10-2] are
free.
► Replace the top section [2-1] and close the
locking clips [2-2].
7.9 Volumetric flow monitoring
An acoustic warning signal sounds if the air
speed in the suction hose falls below 20 m/s.
The table on the mobile dust extractor
explains this connection for the mini
mum required extraction volume of
the respective hose diameter. If the
rate is below the respective extraction
volume, a warning signal is emitted.
* only for EU versions of CT AC
Possible causes Solution
Value set on the suction power adjust
er [1-10] is too low.
Set the suction power adjuster to a higher value (see
Chapter 7.4).
Rotary knob [1-9] not set to the cor
rect hose diameter.
Set the knob to the correct hose diameter (see Chap
ter 7.1 ).
Suction hose blocked or kinked. Remove blockage or kink.
Filter bag full.
Insert a new filter bag (see Chapter 7.7 ).
Filter element clogged.
Change the filter element (see Chapter 9.1).
Only AUTOClean: Clean filter element (see chapter 8.2).
Monitoring electronics malfunction. Send to a Festool service workshop for repair.
Wet extraction. Functional reliability not affected, no actions required.
English
17