17
Dia cutting system DSC-AG 230
1 Technical data
Exhaust Cover DCC-AG 230
Tool 230 mm
Disc thickness
with a bar max. 3 mm
without a bar max. 6.5 mm
Cut depth 59 mm
without a guide bar 63 mm
Exhaust hose 27/36 mm
Weight 3.2 kg
Angular grinder AG 230-26 R
Voltage 220 – 240 V
Frequency 50 / 60 Hz
Power consumption 2600 W
Idle number of revolutions 6600 min
–1
Peripheral speed 80 m/s
Grinding spindle thread M 14
Starting current reduction •
Weight 5.9 kg
Protection level II /
2 Symbols
Double insulation
Warning of general danger
Risk of electric shock
Use protective goggles!
Wear ear protection!
Read the instructions
Not to be included in municipal refuse
Advice or tip
3 Control elements
[1-1] Arresting button
[1-2] Exhaust Cover
[1-3] Power cable
[1-4] Angular grinder
[1-5] Threading for clamping and additional
handle
[1-6] Spindle locking plunger
[1-7] Rollers
[1-8] Screw for setting bar clearance
[1-9] Bar guide
[1-10] Gear box
[1-11] Bar guide
[1-12] Cut indicator
[1-13] Additional handle
Accessories that are illustrated or described here
are not always included in the scope of delivery.
The specifi ed illustrations can be found at the be-
ginning of the operating instructions.
4 Intended use
Consisting of an angle grinder and extraction
hood, the Dia cutting system is designed for
grooving and cutting into concrete or stone ma-
terials without the use of water.
The exhaust cover is not intended for use with
grinders with AutoBalance unit (machines marked
AB), risk of cutting into guide rail and false cut
indicator reading.
The user proper is responsible for improper us-
age.
5 Notes on Safety Prevention
5.1 General safety instructions
WARNING! Read all safety warnings and
all instructions. Failure to follow the warn-
ings and instructions may result in electric
shock, fi re and/or serious injury.
Save all warnings and instructions for future
reference.
The term „power tool“ in the warnings refers to
your mains-operated (corded) power tool or bat-
tery-operated (cordless) power tool.
5.2 Safety instructions for all operations
General safety instructions for grinding, abra-
sive cutting and wire brushing:
a) This power tool is intended to function as
grinding, sanding with sandpaper, wire brush-
ing and abrasive cutting. Read all safety warn-
ings, instructions, illustrations and specifi ca-
tions provided with this power tool. Failure to
follow all instructions listed below may result
in electric shock, fi re and/or serious injury.
b) Operations such as polishing is not recom-
mended to be performed with this power tool.
Operations for which the power tool was not
designed may create a hazard and cause per-
GB
To Next Page
Loading...
