3/3
530/05
530/07
530/06
Our example for use is a recommendation tried and tested in practice. However the
different conditions are completely outside of our control. We therefore do not provide
any form of guarantee. Any legal claims arising out of this are not to be made against
Festool. Make sure you follow the safety directions and product instructions provided
with the product.
www.festool.com
Preparing the router
Mount copying ring dia. 30 mm on the router and centre it by using •
the centring mandrel (not applicable for the OF 1400 and the OF 2200).
Attach extractor hood and extractor hose. •
Insert the groove cutter in the router and tighten. •
Set the speed to 6. •
Drill 8 mm in the centre of the radius in the workpiece. •
Procedure
Insert the routing template with circle routing insert in the hole in the •
workpiece (Fig. 530/05).
Insert router in the copying ring holder. •
Set the routing depth and plunge cut. •
Guide the routing template together with the router in the opposite direc- •
tion (clockwise) up to the scribe mark or the start of the routing (circle)
(Fig. 530/06).
Tip: For complete circle cutouts, care must be taken to cut through
since the centre is no longer securely fixed around which the MFS
is rotated.
To ensure a secure centre position, three or four pieces of wood
can be used for connecting on the back side of the workpiece
(Fig. 530/07). When routing through, these wood pieces will only
be slightly cut but they will nevertheless provide a material inter-
connection.
D
To Previous Page
Loading...
