7.1 Extension Cord
If an extension cord is required, it must have
sufficient cross-section to prevent an excessive
drop in voltage or overheating. An excessive
drop in voltage reduces the output and can lead
to failure of the motor. The table below shows
you the correct cord diameter as a function of
the cord length for this tool.
Cord Size in A.W.G
Tool`s Ampere Rating Cord Length in Feet
25 50 100 150
3-6 18 16 16 14
6-8 18 16 14 12
8-10 18 16 14 12
10-12 16 16 14 12
12-16 14 12 - -
Wire Sizes in mm
2
Tool`s Ampere Rat
ing
Cord Length in Meters
15 30 60 120
3-6 0.75 0.75 1.5 2.5
6-8 0.75 1.0 2.5 4.0
8-10 0.75 1.0 2.5 4.0
10-12 1.0 2.5 4.0 -
12-16 - - - -
Use only NRTL listed extension cords.
Never use two extension cords together. In
stead, use one long one.
The lower the AWG number, the stronger
the cord.
7.2 Switching on/off
The switch
[1-13] is an on/off switch (press =
ON, release = OFF).
The on/off switch with the locking button [1-12]
can be engaged to operate in continuous mode.
Press the on/off switch again to release the
lock.
8 Settings
WARNING
Risk of injury, electric shock
► Always disconnect the mains plug from the
socket before performing any work on the
machine.
8.1 Electronics
Speed control
You can continuously adjust the speed within
the speed range using the adjusting
wheel
[1-10] (see "Technical data").
This enables you to optimise the cutting speed
to suit the respective material.
Mate
rial
Cutter diameter Recom
mended
cutting
material
10–
25 mm
25–
40 mm
40–
60 mm
3/8"–1" 1"–
1-1/2"
1-1/2"–
2-3/8"
Adjusting wheel setting
Hard
wood
6–4 5–3 3–1 HW
(HSS)
Soft
wood
6–5 6–3 4–1 HSS
(HW)
Coated
chip
board
6–5 6–3 4–2 HW
Plastic 6–4 5–3 2–1 HW
Alumi
nium
3–1 2–1 1 HSS
(HW)
Plas
ter
board
2–1 1 1 HW
Temperature cut-out
The power supply is restricted and the speed
reduced if the motor exceeds a certain temper
ature. The power tool continues operating at re
duced power to allow the ventilator to cool the
motor quickly. The power tool starts up again
English
10
To Next Page
Loading...