Fetco XTS Series - Water Tank Cleaning Procedure

CLEANINGANDPREVENTATIVEMAINTENANCE
ForFetcoXTS,V+&ExtractorSeriesBrewers&LuxusDispensers
WA TERTANKCLEANINGPROCEDURE
(for Urnex or Scale Kleen type food‐safe products)
IMPORTANT: thisproceduremustbeperformedbyatrainedservicetechnician.
Thisprocedureisnotintendedforthegeneralpublicorfortheenduser.
Machine should be up to temp and ready to brew before starng this procedure. The
machine needs hot water to acvate the cleaning chemicals.
Turn off the brewer main power switch and circuit breaker, unplug the brewer (if this is
possible) and test for NO power.
Remove the circular tank access cover at the top of the tank. (Cauon tank will probably
be hot) and set it to the side.
Pour in de‐scaling solvent through the access cover and sr to dissolve the powder.
Let descaling soluon sit for 45‐60 minutes and then use a brush to knock any scale and
lime deposits loose wherever possible.
Drain all water from tank of brewer. (Drain plug is located at back of brewer).
Vacuum any excess debris from inside of tank with a shop‐vac if possible.
Restore power to brewer, turn brewer on, brewer will re‐fill tank and heat automacally.
Run at least 3 brew cycles to remove any excess cleaning chemicals from the unit.
(Repeat if needed). Use sanizer if required.
Make sure there is no residue le from the cleaning procedure.
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.