Page 3
Introduction
Thank you for purchasing the FETtec FC F7. This is a KISS licensed F7 Flight-controller
Features
• KISS FC v2 firmware (FETtec Alpha FC firmware flashable)
• F7 Processor
◦ STM32F7RET6 @ 216MHz
◦ MPU6000
• Supply voltage 6-27V (2S-6S Lipo)
• Dedicated onboard 5V BEC for VTX (max 600mA)
• 8 pin connector for solder free ESC connection
◦ Connector 1: ESC signal 1-4, telemetry, VCC, GND
◦ Connector 2: ESC signal 5-8 (depending on UAV type 1-4), telemetry, VCC, GND
• 5 UART serials
◦ UART 1 free
◦ UART 2 used for Receiver
◦ UART 3 free
◦ UART 4 used for onboard OSD, can be set free
◦ UART 5 used for ESCs / TLM / Onewire
• Build-in real Pit-Mode for unify nano (via VTX Pin and 5V on SER1)
• 4 ESC solder pads (Signal/GND) in each corner
• Direct places for RX and VTX (unify nano, CRSF nano, FrSky R9)
• Buzzer pads
• Supported ESC protocols
◦ PWM, Oneshot125, Oneshot42, Dshot150/300/600/1200/2400, FETtec Onewire
• Dimensions 35x30mm without 30x30 corners
◦ 20x20mm (with breakable holes M2 to M3)
◦ 30x30mm hole distance useable (breakable 30x30mm corners)
• Overall height: 7,9mm
• Weight: 5,37g
• Connector type: JST-SH-1mm
To Next Page