28
6. Before repair is performed or before replacement of the telephone, it
must be disconnected from the voltage supply. If it is unavoidable
that the power be switched on during servicing or repair, then this
must only be performed by suitably trained specialist personnel.
7. The stipulated position of utilisation must be adhered to. The
telephone must be installed on a plane surface only, in vertical
operating position.
8. In the open state of the telephone no dust may ingress the device.
9. Upon mounting or demounting the device, do not damage the cover
seal, which keeps the cover tight, or the collar on the lower part of
the housing.
10. Magnetic fields with energy technical frequencies can cause a slight
impairment of the listening quality. If this is the case, please ensure
that the telephone is installed at a suitable location.
11. If there is a high concentration of sulphurous gases in the
environment, the lettering of the keys can fade and a rust film can
arise.
12. Changes to the product which are in the interests of technical
progress are possible even without prior notice.
CE symbol
The ResistTel fulfils the requirements of the R&TTE Directive - 1999/5
EG (Radio equipment and telecommunications terminal equipment and
the mutual recognition of their conformity)
In detail the ResistTel complies with the Low Voltage Directive
73/23/EWG and the EMC Directive RL89/336/EG for the domestic /
residential and industrial areas.
The conformity of the ResistTel with the above-mentioned directives is
confirmed by the CE symbol.
EMC-Directive
The device complies with the requirements of the new EMC-directive
2004/108/EC, the low voltage directive 2006/95/EC and the R&TTE
directive 1999/5/EC.
The conformity with the above directives is confirmed by the CE sign.
To Next Page
Loading...
