Farmer-HelperSG24 Stump Grinder 9 Revision 12-12-2017
MAINTENANCE
1. Proper and routine maintenance is critical to operator safety, achieving proper stump
grinding results and in prolonging the life of the machine.
2. For cleaning and maintenance of the stump grinder, switch off the tractor PTO shaft and
turn the engine off.
3. Inspect the unit before each use for loose nuts and worn cutting teeth. Also clean any
build up of debris.
4. After 2 hours of operation, check for loose nuts and worn cutting teeth. Tighten and
replace as necessary.
5. Grease the bearings and the pivot pins on the main housing as needed before each use.
Do not over grease the the bearings as this will blow out the seals and cause premature
bearing failure.
6. Inspect the clutch plates on the PTO shaft periodically to ensure that they are not
seized together. Refer to “PTOShaftClutchRunIn” in the “StumpGrinderSetUp
Procedures” section of the manual.
To Next Page
Loading...