12
SAFETY BLOCKAGE OF THE KEYS
The keys on the internal plaque can be rendered inactive. Under normal op-
erating conditions these are used for opening (green) and closing (black)
the door using the motorisation on the lock.
This is done to prevent accidental or involuntary opening, which may de-
tract from the security of your home. The presence of children in the home
for example, is one of the conditions that may mar security.
To deactivate the keys:
A. Hold the green and black keys on the internal plaque (fig. 7) down si-
multaneously for at least ten seconds.
B. When the keys are released they are inactive.
To reactivate the keys:
A. Hold the green and black keys on internal plaque (fig. 7) down si-
multaneously for at least ten seconds.
B. When the keys are released they work again normally.
According to the system installed by your installer, your x1R electronic lock
will function with alkaline batteries or will be powered by mains-recharge-
able batteries.
In both cases, the batteries are housed at the edge of the door and all you
have to do, to access them to replace or maintain them, is loosen the screws
located on the front of the battery holder and take it out with care
(fig. 7).
When replacing the batteries, comply with the indications and the techni-
cal data listed below in this manual, then replace the battery holder, taking
care not to damage the electricity cables, and fix it with the screws provid-
ed.
Alkaline batteries: 1,5V Ni-Cd Type D
Rechargeable batteries: 1,2V Ni-Mh Type D
2
Fiam consiglia l’utilizzo di pile
3
2
BASIC PROGRAMMING
BATTERIES
FIG.8
FIG.7
To Next Page
Loading...