13
Read this section carefully to make sure the product is working sat-
isfactorily to guarantee you with the maximum security.
Both your door manufacturer and installer have carried out trial tests using
a general code. Now you must NECESSARILY store your personalized code
number and that of your electronic keys , where required, in the mem-
ory in order to be guaranteed with the maximum security.
You can memorize up to a maximum of 128 code numbers and/or TAG, if
required.
Registering your personalized codes means that no other unautho-
rized code can be used, i.e. the codes (and TAG) registered by you will
be the only electronic commands capable of opening your door.
PRELIMINARY PHASE: MEMORIZING THE NEW ENTRANCE CODES
Numeric codes must be programmed at two different levels: at least one at
“master” level whilst the others will be at “service” level.
The “master” codes enable their holder to:
• open the lock
• have access to programming
• change the functional mode
• activate new codes and/or "master" keys
• activate and deactivate “service” codes and/or keys
• totally reset the memory
With the enabled “service” codes the holder may:
• open the lock
Personalized codes, be they either “master” or “service”, must be
made up of a minimum of four to a maximum of eight figures.
If your system includes using both keyboard and TAG x.Keys, you must
first follow the instructions for memorizing the numeric codes, then go
to page 5 of this manual where you will find details on how to register
and use the transponders.
4
BASIC PROGRAMMING
SYSTEM WITH KEYBOARD AND INTEGRATED TAG TRANSPONDER
To Next Page
Loading...